AI parts search for appliance parts stores
Homeowners and repair techs search by symptom and appliance — “my dryer runs but won’t heat” — not by part number. AI Parts Finder matches that to the exact heating element, drain pump, igniter, or sensor on your store. These are real appliance-repair questions the finder answers.
Real Appliance Parts questions, answered live
Every example below is a genuine shopper question — no part number — matched to the exact part. It’s the same engine that runs on your storefront widget.
“My Whirlpool dryer still tumbles and runs, but the clothes come out cold and damp — it just won’t get hot anymore. What part do I need?”
On an electric dryer the heating element is a coil that glows red to warm the incoming air. When one of those coils burns through and breaks, the drum keeps turning but you get no heat at all. A new element restores full heat — the single most common no-heat repair on these Whirlpool-built dryers (also sold as Kenmore, Maytag, Roper, Estate).
→ Recommended: Dryer Heating Element, Whirlpool / Kenmore · $62.80
“My Whirlpool washer fills and washes fine but at the end the tub is still full of water and the clothes are soaked — it won’t pump out. What do I replace?”
The drain pump is what pushes water out of the tub at the end of the cycle. When its motor fails or the impeller cracks, the machine finishes the wash but leaves standing water behind (sometimes with an error code or a humming pump that won’t move water). A new drain pump gets it emptying again.
→ Recommended: Washer Drain Pump, Whirlpool (OEM) · $114.94
“My GE refrigerator isn’t holding temperature — the food section is getting warm and the cooling seems off, but nothing’s obviously broken. Where do I start?”
GE fridges use a small temperature sensor (thermistor) that tells the control board how cold it is and when to run cooling and defrost. When the thermistor drifts or fails, the board gets a bad reading and either under-cools or skips defrost, so the box warms up. It’s inexpensive and a high-frequency failure — the cheapest thing to rule out before a control board.
→ Recommended: Refrigerator Temperature Sensor / Thermistor, GE · $18.92
“The stovetop burners on my Frigidaire gas range light fine, but the oven won’t heat up — it never gets hot. What’s the part?”
On a gas oven the igniter has two jobs: glow hot to light the burner and draw enough current to open the safety gas valve. As it ages it weakens — it may glow dull orange but no longer pull enough amperage to open the valve, so gas never releases and the oven stays cold. A weak igniter is by far the most common reason a gas oven won’t heat.
→ Recommended: Oven Bake Igniter (Flat Style), Frigidaire / Electrolux · $45.30
“The ice maker in my Samsung fridge quit making ice — the freezer is cold and everything else works, but no new cubes. What do I need?”
Samsung builds most of the ice-making components (mold, heater, motor, bail arm) into one sealed assembly and doesn’t sell the internal pieces separately, so a failed motor or mold heater means replacing the whole unit. If the freezer is holding around 0°F but you’re still getting no ice, this assembly is the standard replacement.
→ Recommended: Refrigerator Ice Maker Assembly (9-cube), Samsung · $157.51
“My Maytag dishwasher leaves a pool of dirty water in the bottom after every cycle and won’t pump it out. What part do I need?”
The drain pump is a separate motor that pushes wastewater out to the sink drain at the end of the cycle. When its impeller jams or the motor windings fail, the dishwasher runs normally but can’t evacuate the water, so you’re left with a puddle in the sump. A new drain pump clears it — the same Whirlpool-built pump fits Maytag, KitchenAid, Kenmore, and Whirlpool.
→ Recommended: Dishwasher Drain Pump, Maytag / Whirlpool (OEM) · $59.95
Put this on your appliance parts store
14-day free trial, installs from your Shopify theme in minutes, and it only ever recommends parts from your own catalog — never a competitor or a marketplace.